TELUS satellite TV remote Code

Looking for Optik TV remote instructions? Find your remote here.

Before you begin

• Check to see if your batteries need replacing
• Verify your receiver is plugged into a working power outlet
• Locate the remote codes for the TV:

Follow these steps to program your remote control

1. Press and hold the TV button on the remote until the SAT, VCR and AUX buttons light up.
2. Let go of the TV button. It should start to flash.
3. While the TV button is flashing, enter one of the 3-digit codes for the TV that you wrote down earlier.
4. After entering the 3-digit code, press the # button on the remote. If the code was entered successfully, the TV light will flash 3 times.
5. Try to control the TV's volume and power.
6. If the remote did not control the TV, simply repeat steps 1 to 5 with another code from the list.

If you tried all the codes provided for the manufacturer without success, try the following

1. Make sure the TV is on.
2. Press and hold the TV button on the remote until the SAT, TV and VCR buttons light up.
3. Let go of the TV button. The TV button should start to flash.
4. Press the Power button on the remote control. The TV button will stay lit.
5. Press the up arrow on the remote every second until the TV turns off.
6. When the TV turns off, press the # button on the remote to lock the code. If the scan was successful, the TV light will flash 3 times.

Your remote should now be programmed to work with your TV.

Note: Unfortunately, while we try to accommodate every type of television, some may not be supported.